Series frequent start vibrating motor. 1, this series vibration motor should be checked before unpacking is complete, with or without signs of damp. 2. Check the product nameplate data is in compliance with the requirements of the order. 3, with a 500-volt megger insulation resistance, and its value should not be less than 0.5 megohms otherwise respond to the stator windings drying, drying temperature must not exceed 125. 4, subject to the mounting surface machining, surface smooth, not allowed to have male and female phenomenon. 5, the installation site should be easy to monitor electrical inspection, cleaning and maintenance. 6, this series vibration motor control all electrical equipment and connections should comply with electrical safety requirements, wiring and reliable. Electrical motor using four-core rubber cables, rubber cables exit port allows the chicane, the minimum bend radius must be greater than 50 mm of cable insulation material with a soft pad is good, and with the vibrating body fixed. 7, install the machine foot holes: vibration motor four, six or eight foot bolts should be based on the choice of the appropriate pore size of not less than 8.8 for high strength bolts, bolt length is determined by the user to install, reliable tight with wrench Solid and use against rotation. Vibration motor test run 10-20 minutes, check the bolt tightening torque. If necessary tighten again. 8, adjust exciting force: when the unit is shipped to adjust the excitation force to 70% of the maximum excitation force, if need other exciting force value, adjusted by the following methods: a, semicircular or stepped excitation Block adjust exciting force. First remove the vibration end shield, and then adjust the bolts loose excitation block A, turn this exciting block, will adjust the excitation of a shoulder block alignment adjustment needed signs data, and then provide a good fixing bolts can be. b, fan-shaped excitation block adjust exciting force. First remove the vibration end shield, and then adjust the bolts loose excitation block A, turn this exciting block, the block reference point for adjustment of alignment adjustment signs exciting data needed, and then provide a good fixing bolts can be. Note: The exciting force adjustment should ensure the same on both sides of the vibration motor excitation block to adjust the angle, that both sides should be adjusted in the same block excitation setpoint position, otherwise exciting force will be uneven, resulting in reduced vibration and motor life vibration effects. 

keywords: Vibration motor, three-phase asynchronous motor vibration, high-frequency vibration motor,